Tap Wrench & Hexagon Key Suppliers in Hobart

A wrench is a tool used to turn nuts and bolts, while a hexagon key (also known as an Allen key) is a tool used to tighten or loosen screws or bolts with a hexagonal socket. Wrenches come in various sizes and shapes, while hexagon keys are typically L-shaped and come in a set of different sizes.

However, wrenches and hexagon keys come in a variety of sizes, ranging from very small to very large. Common sizes for wrenches include 6mm, 8mm, 10mm, 12mm, 13mm, 14mm, 15mm, 17mm, 19mm, and 22mm. Hexagon keys, also known as Allen keys, are typically available in sizes ranging from 0.7mm to 19mm. It's important to note that the specific sizes available may vary depending on the manufacturer and the type of tool.

Wrenches and hexagon keys can be made from a variety of materials, including steel, chrome vanadium, titanium, and aluminum. The choice of material depends on the intended use of the tool, as well as factors such as strength, durability, and weight. Some high-end wrenches and hexagon keys may also feature ergonomic handles made from materials such as rubber or plastic for added comfort and grip.

However, some of the top-rated brands for wrenches and hexagon keys include Craftsman, Snap-On, Kobalt, GearWrench, and Husky. It ultimately depends on the specific needs and preferences of the user.

Yes, wrenches and hexagon keys can be purchased individually or in sets.

However, the price range for wrenches and hexagon keys can vary depending on the brand, size, and quality. Generally, basic wrenches and hexagon keys can cost as low as $5, while high-end and specialized tools can cost over $100.

To determine the size of wrench or hexagon key you need for a specific job, you can follow these steps:

• Identify the type of fastener you need to work with. Is it a bolt, nut, or screw?
• Measure the diameter of the fastener. You can do this with a caliper or ruler. For bolts and nuts, measure across the flats (the sides that are flat and parallel to each other). For screws, measure the diameter of the shank (the unthreaded part).
• Look up the corresponding size in a wrench or hexagon key size chart. These charts are widely available online and in hardware stores.
• Choose the appropriate size wrench or hexagon key for the job.

It's important to use the correct size tool to avoid damaging the fastener or the tool itself.

No, it is not recommended to use a metric wrench on an imperial bolt or vice versa. The sizes and measurements of metric and imperial bolts and wrenches are different, and using the wrong size can damage the bolt or wrench and result in unsafe or ineffective tightening or loosening. It is important to use the correct size and type of wrench for the corresponding bolt or nut.

To maintain and care for your wrenches and hexagon keys, you should follow these steps:

• Keep them clean and dry: After using your wrenches and hexagon keys, wipe them clean with a dry cloth to remove any dirt or debris. Make sure they are completely dry before storing them.
• Store them properly: Store your wrenches and hexagon keys in a dry and clean place. You can use a toolbox or a tool cabinet to keep them organized and protected from dust and moisture.
• Lubricate them: Apply a small amount of lubricant to the moving parts of your wrenches and hexagon keys to prevent rust and corrosion. Use a light oil or silicone spray for this purpose.
• Inspect them regularly: Check your wrenches and hexagon keys for any signs of wear or damage. If you notice any cracks, chips, or other defects, replace them immediately.
• Use them correctly: Always use the right size and type of wrench or hexagon key for the job. Avoid using them as hammers or pry bars, as this can damage them.

By following these simple tips, you can keep your wrenches and hexagon keys in good condition and extend their lifespan.